![](/jointfilesconvert/143517/bg1.png)
KVR16LR11D8/4
4GB 2Rx8 512M x 72-Bit PC3L-12800
CL11 Registered w/Parity 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 512M x 72-bit (4GB)
DDR3L-1600 CL11 SDRAM (Synchronous DRAM), low voltage,
registered w/parity, 2Rx8 ECC, memory module, based on
eighteen 256M x 8-bit FBGA components. The SPD is pro-
grammed to JEDEC standard latency DDR3-1600 timing of
11-11-11 at 1.35V and 1.5V. This 240-pin DIMM uses gold
contact fingers. The electrical and mechanical specifications
are as follows:
FEATURES
• JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~
1.575V) Power Supply
• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• On-DIMM thermal sensor (Grade B)
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component
Document No. VALUERAM1345-001.A00 05/02/13 Page 1
Memory Module Specifi cations
SPECIFICATIONS
CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 160ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power (1.35V) = 3.057 W*
(1.50V) = 3.489 W*
UL Rating 94 V - 0
Operating Temperature 0
o
C to 85
o
C
Storage Temperature -55
o
C to +100
o
C
*Power will vary depending on the SDRAM and
Register/PLL used.
Continued >>
Comments to this Manuals